Home → DocuSketch Full Service User Manual → Creating/Uploading Tours → Creating Tours on the Mobile App (Android)
8.1. Creating Tours on the Mobile App (Android)
This module will teach you all the steps you need to know in creating a DocuSketch Tour.
Assuming you have already created, completed and synced an inspection from the OnePoint app, here are the steps on how to complete a DocuSketch 360 Tour:
Step 1: After successfully logging in to the app, tap on "New" to create a new tour.
Step 2: Add all the necessary fields for your new tour. Do note that you may also add a still photo as the banner image of the tour.
Note that the property address is optional and can be skipped. However, the camera height is very important as it is the basis for the sketch measurements. It is important to keep the camera height consistent throughout the shoot and highly accurate.
Step 3: Tap on "Done".
You have successfully created a new tour. Now it's time to add some rooms.
Step 4: Tap on "Add room".
Step 5: Ensure that these fields are properly set.
Label the room or area name and categorize it relative to the floor or area they belong to.
Exterior shots can be placed on the "Outside" under the Floor selection.
Again, the camera height is most important as our system uses the Camera Height as basis for the measurements.
Most will also have a ceiling height field which is optional and mainly needed if you are shooting an overly cluttered room.
Step 6: Click on New Shot.
A pop-up screen should appear at the bottom of the screen.
You can opt for either the Quick Shot (where you take one photo on each side of the camera separately) above or the Single Shot (where you take one photo from both sides of the camera in one tap) below:
You can also opt to turn on HDR to take your photo/s in high definition. Note that this will take approximately 3 seconds longer per side.
Step 7: Take a photo of the room using your 360 camera. You can reshoot if you want by clicking on "Reshoot" or add another photo by clicking on "Yet another shot".
Important reminder: Keep the camera height the same at all times. Also, it's important that you don't get in the camera's way when shooting.
Step 8: Once you're done with all the changes to your room, click on the back button. Repeat Steps 2-5 until you finish all the rooms you wish to edit.
Step 9: Click on the back button to when done with all the edits to the rooms of your tour.
Step 10: Once you see the "Upload needed" indicator, that means you still need o upload all your changes. To do so, click on the three dots beside the tour name.
Step 11: Click on Upload. The "Upload needed" indicator will automatically be removed once the upload is successful.